Operation - Carrera №651 Manual De Instrucciones

06. OPERATION

¯
DANGER of injury as a result of scalding
Always ensure the lid is closed while heating the water; otherwise,
boiling water may spurt out!
Do not open the lid while the water is boiling.
● ●
When filling the glass kettle, do not exceed the maximum filling level
● ●
(MAX 1.7 L); otherwise, boiling water may spurt out.
Do not bend over the glass kettle when opening the lid while the content
● ●
is still hot. There is a danger of scalding caused by the escaping steam.
The glass kettle gets very hot during operation. Only touch it by the
● ●
handle and only operate the unlocking button.

CAUTION! Material damages
Fill the appliance with at least 0.5 l of water; otherwise, the appliance
may overheat.
Drinking water
Water is very sensitive and may spoil due to germ formation. Please observe
the following:
Always use fresh drinking water in the glass kettle.
● ●
Pour away water which has been in the glass kettle for more than approx. 1 hour.
● ●
Do not re-boil the water.
● ●
Boiling water
1. Remove the glass kettle from the base station.
2. Press the unlocking button to open the lid.
3. Fill the desired quantity of fresh drinking water into the glass kettle. Hold
or place it vertically so that you can properly read the water gauge.
4. Close the lid by pressing it down.
5. Place the glass kettle on the base.
6. Connect the mains plug to a socket that matches the technical data.
The 100 °C temperature display flashes by default. After 1 minute without
any selection, the display switches off.
7. Use the START/STOP button to switch on the glass kettle; the START/STOP
LED will light.
8. Select the desired water temperature with one of the temperature setting
8
buttons . The heating process is started with START/STOP. The tempera-
ture LED flashes until the desired temperature has been reached. It remains
lit while the START/STOP LED goes out with a sound signal (5x beep). The
temperature setting may also be adjusted during the boiling process.
GB 27