Vissani QR254S Manual Del Usario página 13

Installation (continued)
B .2 FRAMED CABINET BRACKET INSTALLATION
- Refer to the marking on brackets to determine their
correct installation side and orientation .
- Flat end of the bracket with the arrow should face
towards you and the notched end should face the wall .
- Align the bracket against the inside edge of the 30 in
(762 mm) cabinet cabinet frame and the back wall . Mark
the location of 3 holes (out of the available 6 holes) as
shown in fig. 19-1.
- Set the bracket aside and drill three 7/64" holes in the
marked locations as shown in figure 19-2
- Secure the bracket to the side frame using a screwdriver
and provided 18mm wood screws (AA) . If a given
pre-drilled pilot hole has stripped, use the adjacent
mounting hole instead .
Repeat the above procedure to install the remaining framed
cabinet bracket on the opposite side of the cabinet .
Please contact vissani@conglom.com or 1-888-449-9197 between 8:30 am - 5 pm, EST, Monday - Friday for further assistance.
7/64"
13
Fig . 18
Fig . 19-1
Fig . 19-2
AA
Fig . 19-3