Publicidad
Idiomas disponibles
Idiomas disponibles
Handling intructions
for removable ball with eccentric system
Remember:
Manually (without applying any aids) carry out the releasing or engaging actions on
–
the latch lever (4).
When nothing is drawn, the drawing ball (1) shall be removed from the house (3),
–
because it reduces the visibility of the car registration plate.
In order to maintain a trouble-free operation of the moving component parts of the
–
house (3) during the whole period of guarantee, when nothing is drawn for a while,
after removing the drawing ball, put the end cap (wich can also be used as cover
piece of the drawing ball) onto the open end of the house (3).
Always apply grease onto the drawing ball (1) to achieve a better abrasion
–
resistance (type LZS-2 or equivalent is recommended).
The drawing ball and the latch lever should always be taken with yourself (for
–
instance, in the luggage trunk), even when they are in dismounted state. The
carrying case supplied should be used for this purpose.
Dismounting the drawing ball:
Pull down the guard pin (5) from the end of the latch lever (4).
–
Pull aside the latch lever (4) to the right to the maximum possible extent, then turn it
–
applying an angle of 90°. In this case, it will not bump into the washer (2) when it is
loosened. Finally, let it go back to its original position.
Loosen the latch lever (4) and rotate until it can easily be pulled out of the house (3).
–
Take the drawing ball (1) out of the house (3).
–
Put the end cap onto the open end of the house (3), so that the washer (2) can fit
–
into the groove of the cap.
Mounting the drawing ball:
Remove the end cap.
–
Push the drawing ball (1) completely into the house (3) in upside-up position, until
–
catch.
Push the latch lever (4) through the bore of the house (3) and the stalk of the
–
drawing ball (1).
Slide the guard pin (5) onto the end of the latch lever (4).
–
Fasten the latch lever (4), then pulling into left hand side direction, rotate it around
–
its axis upwards, until the green arrow on the latch lever reaches the green zone on
the stalk of the drawing ball (at this stage of the procedure the latch lever shall be
parallel with the stalk of the drawing ball).
20
Publicidad
