Assembly - POBEL 720 720 Manual De Instrucciones

1.6.Assembly

Steps to follow:
1. 1. Be sure
(washer of silicone rubber, guide fitting and
PBTP nut) are in the order and position that the
fig. 1 shows.
2. Insert the heater through the screw mouth
(see fig. 2); hold the heater of the fitting (fig. 1,
Rev. 020913
that heater elements
Fig. 1
Fig. 2
piece 2) – and do not of the cap (fig. 1, piece 1) –
and turn the PTPB nut (fig. 1, piece 3)
3. Be sure of putting the filter, of tightening
and connecting the other end to the tap.
• Once you have assembled, check:
- The silicone tubes hold suitable position to
let water pass and to avoid water pressures.
Pag: 8