Eden Birdlip Manual De Instrucciones página 2

Dear Customer,
Congratulations on purchasing your new Eden greenhouse.
Before you start, please read this instruction booklet carefully. The components for your
greenhouse are in numbered bundles corresponding to the sections in this booklet.
There may be more than 1 bundle per section. Build one section at a time. IF YOUR
GREENHOUSE IS POWDERCOATED, TAKE CARE WHEN OPENING PACKAGES NOT TO
SCRATCH PAINTWORK.
NOTE: These instructions are for more than one length of greenhouse.
Precautions
•
Please allow plenty of time for construction.
•
Assembly must be carried out in dry and calm weather.
•
A minimum of two people are required to construct the greenhouse.
•
We recommend using the tools supplied to tighten bolts. Electric drills can lead to
cross threading issues and bolts shearing.
•
Place step ladder on level ground.
•
Extreme care should be taken when handling glass: always use appropriate gloves
and goggles while glazing. Greenhouse glass can have sharp edges, especially if
there are any breakages.
•
Do not, under any circumstances, climb step ladders whilst carrying glass.
•
If there are any breakages, pick up broken glass immediately taking care to keep
children and pets away until completely cleared.
•
We also recommend using protective gloves and goggles when fitting spring wire
clips due to the extreme tension. There are helpful videos under the "Help and
Advice" tab on our website www.edengreenhouses.com
Tips booklet.
Tools supplied
1 x Box spanner
1 x 10mm flat spanner
GB - Introduction
Tools and safety equipment
Recommended
•
•
•
•
•
•
•
•
•
•
Selecting a site
The location of your green-
house is very important. The
structure needs to get as much sunlight as much as possible but should not be exposed to high
winds. Try to avoid locating your greenhouse under trees as this will cast shade, which encour-
ages a build-up of algae and falling branches or leaves could cause damage to the structure or
block guttering. Sap from trees can make the glazing sticky and dirty so it lets in less light. Cre-
ating a level and square base is the most important step in successfully assembling your green-
house: selecting a site that is already quite level will make the assembly process much easier.
Site preparation
Please refer to the front cover of this booklet for the OVERALL dimensions of your greenhouse.
as well as a Hints and
If you are siting the greenhouse on earth, you will need to dig 6 holes for the ground anchors, as
shown in SECTION 0, FOUNDATION, approx. 300mm deep x 200mm in diameter. You will need
post concrete for the ground anchors and, depending on your soil type, you may need plastic
pipes to stop the ground crumbling in on itself. If you are siting the greenhouse on slabs/
concrete, cut the ground anchors off with a hack-saw so that they are level with the base as
shown in SECTION 8 LOCATING, pic 2. To secure the base down pour concrete into pre dug
holes with ground anchors situated in place. For slab/concrete foundation, using the L-shaped
brackets provided, drill into the concrete/slabs using a 7mm masonry drill bit and secure
using 7mm plugs and 6mm x 50mm screws minimum, as shown in SECTION 10 FINISHING.
Eden Greenhouses Customer Helpline: +44 (0)1242 676625
Step ladder
Drill (anchoring only)
Spirit level
Tape measure
Utility knife
Scissors
7mm socket
Screwdrivers – flat, PZ2
Safety gloves
Safety goggles
2.5mm Hex Key
Page 1