Connections; Connecting Vhf And Uhf Antennas - Samsung 6 Serie Manual De Usuario

Ocultar thumbs Ver también para 6 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECTIONS

¦

Connecting VHF and UHF Antennas

If your antenna has a set of leads that look like the diagram to the right, see 'Antennas with 300
Ω Flat Twin Leads' below.
If your antenna has one lead that looks like the diagram to the right, see 'Antennas with 75 Ω
Round Leads'.
If you have two antennas, see 'Separate VHF and UHF Antennas'.
Antennas with 00 Ω Flat Twin Leads
If you are using an off-air antenna (such as a roof antenna or 'rabbit ears') that has 300Ω twin
flat leads, follow the directions below.
. Place the wires from the twin leads under the screws on a 300-75 Ω adapter (not
supplied). Use a screwdriver to tighten the screws.
. Plug the adaptor into the ANT IN terminal on the back of the TV.
Antennas with  Ω Round Leads
Plug the antenna lead into the ANT IN terminal on the back of the TV.
Separate VHF and UHF Antennas
If you have two separate antennas for your TV (one VHF and one UHF), you must combine
the two antenna signals before connecting the antennas to the TV. This procedure requires an
optional combiner-adaptor (available at most electronics shops).
. Connect both antenna leads to the combiner.
. Plug the combiner into the ANT IN terminal on the bottom of the rear panel.
English - 8
ANT IN
ANT IN
UHF
VHF
ANT IN
UHF
VHF

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

6000 serieUn32b6000Un40b6000Un46b6000Un55b6000

Tabla de contenido