Connecting Cable Tv - Samsung 6 Serie Manual De Usuario

¦

Connecting Cable TV

To connect to a cable TV system, follow the instructions below.
Cable without a Cable Box
Plug the incoming cable into the ANT IN terminal on the back of the TV.
N
Because this TV is cable-ready, you do not need a cable box to view unscrambled cable
channels.
Connecting to a Cable Box that Descrambles All Channels
. Find the cable that is connected to the ANT OUT terminal on your cable box.
N
This terminal might be labeled 'ANT OUT', 'VHF OUT' or simply, 'OUT'.
. Connect the other end of this cable to the ANT IN terminal on the back of the TV.
Connecting to a Cable Box that Descrambles Some Channels
If your cable box descrambles only some channels (such as premium channels), follow the instructions below. You will need a two-
way splitter, an RF (A/B) switch and four lengths of RF cable. (These items are available at most electronics stores.)
Incoming cable
. Find and disconnect the cable that is connected to the ANT IN terminal on your cable box.
N
This terminal might be labeled 'ANT IN', 'VHF IN' or simply, 'IN'.
. Connect this cable to a two-way splitter.
. Connect an RF cable between the OUTPUT terminal on the splitter and the IN terminal on the cable box.
. Connect an RF cable between the ANT OUT terminal on the cable box and the B–IN terminal on the RF(A/B) switch.
. Connect another cable between the other OUT terminal on the splitter and the A–IN terminal on the RF (A/B) switch.
. Connect the last RF cable between the OUT terminal on the RF (A/B) switch and the ANT IN terminal on the rear of the TV.
After you have made this connection, set the A/B switch to the 'A' position for normal viewing. Set the A/B switch to the 'B'
position to view scrambled channels. (When you set the A/B switch to 'B', you will need to tune your TV to the cable box's
output channel, which is usually channel 3 or 4.)
Splitter
Cable Box
English - 9
ANT IN
ANT IN ANT OUT
ANT IN
ANT IN
TV Rear
RF (A/B) Switch