Troubleshooting - Garland GAS 359 E Manual De Instrucciones

9. TROUBLE SHOOTING
Depending on the symptoms that you observe, you can probably know the cause of the problem and could even
solve it:

Troubleshooting

The engine does not start
The machine does not blow
The machine does not vacuum
If you cannot solve the problem using this table, take your machine to your service dealer.
To locate your nearest after sales dealer to your house, contact the shop where you bought the machine from.
Cause
The machine is not connected to
the mains
Damaged cable
The machine is not completely
mounted
Damaged switch
The lever of the machine is on
vacuum mode.
Ventilator obstructed.
Tubes obstructed
The lever is on blowing mode.
Ventilator obstructed.
Tubes obstructed.
37/104
Action
Plug the machines to the mains.
Take the machine to the after sales
agent. Never repair the cable with
tape.
Mount the tubes and the catcher.
Take the machine to the after sales
service
Put the lever on the blowing
position.
Open the ventilator compartment
and clean.
Clean the tubes
Put the lever on the vacuum
position.
Open the ventilator compartment
and clean.
Clean the tubes
English