Searching From The Bluetooth Device; Connecting - Sony XAV-70BT Manual De Instrucciones

3
Touch "Search."
Search of connectable Bluetooth devices
starts.* 1 * 2
After search is complete, the list of detected
devices* 3 appears.
*1 If the Bluetooth signal of this unit is off, it
activates automatically when searching starts.
*2 Search time varies depending on the number of
connectable devices.
*3 The name or address (if name is unavailable) of
detected devices are displayed.
4
Touch the device to connect.
5
Select the connection type.
Touch "Handsfree Connect" to use for
handsfree calling.
Touch "Audio Connect" to use for audio
streaming.
Pairing start and the passkey input display
appears.
6
Touch the number keys to enter the
passkey, then "OK."
Perform the required operation also on the
other Bluetooth device.
Pairing is complete and this unit is connected
to the other Bluetooth device.
When connection is made successfully,
appears at the bottom of the display.
Searching from the Bluetooth
device
The procedure to search for this unit from the
other Bluetooth device is explained below.
1
Select the Bluetooth source.
To select Bluetooth Phone, press (TOP), then
touch "BT Phone" in the top menu.
To select Bluetooth Audio, touch "Source
List," then "BT Audio."
2
Touch "BT Menu."
In the case of Bluetooth Audio, touch "Play
Menu," then "BT Menu."
The Bluetooth setting menu appears.
3
Touch "Signal," then "Yes" to set
"Signal" to "ON."
The Bluetooth signal of this unit is activated.
4
Touch "Discoverable" to set to
"Show."
The unit is ready to be detected by the other
Bluetooth device.
36
5
Start searching for this unit from the
other Bluetooth device.
After search is complete, this unit appears as
"Sony Automotive"* in the list of the other
Bluetooth device.
* Can be changed in the Bluetooth setting
(page 44).
After you perform the required operation on
the other Bluetooth device, the passkey input
display appears on this unit.
6
Touch the number keys to enter the
passkey, then "OK."
Pairing is complete and this unit is connected
to the other Bluetooth device.
When connection is made successfully,
appears at the bottom of the display.
Notes
or
• While connecting to a Bluetooth device, this unit
cannot be detected from another device. To enable
detection, disconnect the current connection and
search for this unit from another device.
• Depending on the device, searching from this unit
may not be possible. In this case, search for this unit
from the other device.
• If you search for this unit and the other device
mutually at the same time, this unit will not recognize
the other device.
• It may take time to search or connect.
• Depending on the device, the connection
confirmation display appears before inputting the
passkey.
• The time limit for inputting the passkey differs
depending on the device.
• This unit cannot be connected to a device that
supports only HSP (Head Set Profile).

Connecting

When the ignition is switched to on with the
Bluetooth signal activated, this unit searches for
the last-connected Bluetooth device, and
connection is made automatically if possible.
This chapter explains how to connect manually
to registered Bluetooth devices.
Before starting, be sure to activate the Bluetooth
signal both on this unit (page 44) and the other
Bluetooth device.
DR-BT30Q
Sony
Automotive
XXXXXXX
or