Bissell POWEREASE 2253 Serie Guia Del Usuario página 8

Clean the Pre-Motor Filter
WARNING
To reduce the risk of electric shock, turn power switch off and disconnect plug from
electrical outlet before performing maintenance or troubleshooting checks.
WARNING
Do not operate vacuum with damp or wet filters or without all filters in place.
1
Press the Tank Release Button and pull
out to remove Dirt Tank.
3
Allow filter to air dry completely before
placing back into the tank lid.
Maintain the Pet TurboEraser ® Tool
1
Twist gray collar
counter clockwise,
until slot appears,
then separate
faceplate.
8
www.BISSELL.com
2
Remove Brush Roll,
Belt, and Paddle
Wheel. Inspect
for damages and
replace if necessary.
2
Remove Foam Filter from lid. Hand
wash in warm water and rinse well; mild
detergent may be used if desired.
4
3
To reassemble, align two clips on each
end of Paddle Wheel with belt on
and pop back into place. Place Brush
Roll with belt back in. Faceplate will
not close properly if all parts are not
aligned correctly.
click
Return tank back
on vacuum and
press firmly until
you hear "click."