Glacier bay QK011 Guía De Uso página 10

Installation (continued)
INSTALLING THE SINK
NOTE:
Install the faucet according to the manufacturers instructions before completing this step. Install the vanishing edge
instructions before completing this step. See page 11.
- Apply silicone sealant (not included) around the underside of the flange of the sink (A) on all four sides as shown below.
- Install the topmount clips (D) into the clip channels of the sink (A) as shown in the figures below.
- Carefully lower the sink (A) into the counter, ensuring that the topmount clips (D) do not catch on the counter edges .
- Adjust each topmount clip (D) along the rails so that they are evenly spaced around the sink (A) .
- Rotate the clamps of the topmount clips (D) such that they engage the counter, and tighten the screws progressively (see
tightening sequence below) until the sink flange is flush with the counter. Check the alignment as you tighten so that the front of
the sink (A) is parallel to the front of the counter . Adjust and re-tighten if necessary . Do not over tighten .
- Wipe away any excess sealant with a rag and allow it to set before proceeding with the rest of the installation .
A
D
Silicone
Sealant
A
Clamp
SUPPLY LINES (NOT INCLUDED)
The supply lines, which connect the faucet to the household water system, are not supplied with this unit . They need to be purchased separately .
Follow the supply line manufacturer's instructions for proper installation .
QK011
Screw
9
10
Tightening sequence for clips
10
TM strainer according to the
6 2 4
7
8
3 5 1