8. Install blower.
Re-install blower. Secure blower with 2 screws from parts
bag and plug blower into black receptacle.
9. Finish ceiling, then install grille.
Pre-assemble mounting rod to grille pan using lock washer
and jam nut. Hand-tighten jam nut - plus 1/4 turn with a
wrench (10-15 in.-lbs.). Do not overtighten jam nut.
Plug light into receptacle in housing. Attach grille pan to
housing with (2) grille mounting screws. Pull out sliding
shade hook (see arrow) and install glass shade using
hardware as shown. Do not overtighten finial nut. Push
sliding shade hook back into place over glass shade.
JAM NUT
LOCK
WASHER
MOUNTING
ROD
FELT WASHER
FINIAL WASHER
FINIAL NUT
GRILLE
BRACKETS
LIGHT PLUG
GRILLE
PAN
SLIDING
SHADE
HOOK
(2) GRILLE
MOUNTING
SCREWS
FLAT WASHER
GLASS
SHADE
FELT WASHER
RETROFIT
4. Remove old fan.
Enlarge ceiling opening (if necessary) to 9¾" parallel to
joist) by 10½" (perpendicular to joist). Leave ductwork
and wiring in place.
1
5. Fold mounting ears flat against
housing.
2
5