Tabla de contenido
Publicidad
BASIC SHREDDING OPERATION
Continuous operation:
4-5-minute maximum
NOTE: Shredder runs briefly after each pass
to clear entry. Continuous operation beyond
4-5-minutes will trigger 20-minute cool
down period.
ADVANCED PRODUCT FEATURES
SAFESENSE
TECHNOLOGY OPERATION
®
Stops shredding immediately when hands touch the paper opening.
SET-UP AND TESTING
2
1
10
Turn the shredder ON
Touch test area and
( ) to activate
look for the SafeSense
SafeSense
indicator to illuminate
®
BASIC PRODUCT MAINTENANCE
OILING SHREDDER
All cross-cut shredders require oil for peak performance.
If not oiled, a machine may experience diminished
sheet capacity, intrusive noise when shredding and could
ultimately stop running. To avoid these problems, we
recommend you oil your shredder each time you empty
your waste bin.
*Only use a non-aerosol vegetable oil in long nozzle container such as Fellowes 35250
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature
and needs to cool down. This indicator will remain illuminated and the shredder will not operate for the duration of the recovery
time. See Basic Shredding Operation for more information about the continuous operation and recovery time for this shredder.
PAPER JAM
1
2
Press and hold Reverse
Alternate slowly back and forth
(R) 2-3 seconds
PAPER/CARD
2
1
Feed into paper entry
Press Auto-On ( )
and release
3
SafeSense
is active
®
and working properly
®
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1
Set to Off
3
4
Set to Off
and unplug
3
or
Feed into center of
entry and release
H D - 1 0 c
s
H D - 1 0 c
10
s
10
2
3
H D - 1 0 c
s
10
*Apply oil across entry
Press and hold Reverse
(R) 2-3 seconds
15
6
5
Gently pull uncut paper
Press and hold
from paper entry. Plug in.
Reverse (R)
H D - 1 0 c
s
10
4
Set to Off
3
Publicidad
Tabla de contenido
