Operator's guide:
1. Unpacking instructions
2. The handle
3. Grid shelving
I
Round glass shelving
4. Internal cleaning
UK
5. External cleaning
6. Connection to the mains
D
7. Controls
8. Checking correct operation
E
9. Internal cleaning
F
!
WARNINGS (see picture 10).
NL
It is most important that this instruction booklet is kept together with the appliance both for future
reference and for reasons of safety.
P
1
. Adults should operate this appliance only. Do not allow children to use the controls or play with it. . It
is forbidden to modify in any way the main functions and characteristics of this appliance. . The electrical
S
installation of the appliance should be carried out by a qualified electrician or other competent person.
4. Never attempt to carry out repairs unassisted. Inexpert repairs can cause serious damage and
5
malfunction. . Assistance has to be provided by an authorized engineer only. Always use original spare
DK
6
parts. . This appliance is not suitable for the storage of basic commodities not including food-stuffs. . The
manufacturers of this appliance accept no responsibility for the consequences of misuse in contravention
FIN
of these safety instructions. It further reserves the right to carry out improvements without prior notice.
8
. Avoid installing the cabinet directly in line with sunlight. . Never install the appliance near sources of
B
heat (such as radiators, stoves, etc) and drafts (such as windows, doors, ventilation systems, air
conditioning, etc ...). 10
GR
the products displayed on the shelves and grills do not hang over the edges.
to be refrigerated should cause ice to form on the evaporator, we recommend stopping the compressor
CZ
and placing the goods in special refrigerated containers, kept at the same temperature, until defrosting is
completed;if this is not carried out the compressor will continue to operate leading to a wasteful
consumption of electricity and poor performance.
EE
indispensable to keep the door open at least 10 cm.
is off.
LV
Our products are for internal use only – do not install outside restaurants, shops.
!
LT
1. UNPACKING INSTRUCTIONS
H
CARDBOARD PACKAGE 1a
Remove the nails from the wooden crate with care.
M
and pallet or crate.
and level surface. . Make sure there is nothing left in the package before disposal. . Separate the
PL
packaging materials to facilitate disposal (see figure 1).
2. THE HANDLE
SK
1.
The handle can be found in a bag inside the appliance.
the two screws already inserted in the holes. Tighten with care. . Place the plastic insert over the handle
SLO
and press down until it clicks into place (see figure 2).
3. GRID SHELVING
1.
The shelves are in the bottom of the cabinet. . Fit the grids into the height-adjustable supports (see
figure 3)
ROUND GLASS SHELVING PRISMA 400 PG model
1.
Take the shelves from the cardboard box and place them on the supports of the uprights.
mount the mirror shelf at the bottom (see figure 3).
4. INTERNAL CLEANING
1.
Clean the internal parts and glass panels, using soft cloths and neutral detergents. . Dry with a soft
cloth.
5. EXTERNAL CLEANING
1. Use the same products as used for the internal cleaning.
6. CONNECTION TO THE MAINS
1.
Ensure that mains voltage and frequency are the same as those stated on the rating plate
to the appliance.
earthed.
It fulfils the requirements of the rated current as set out on the rating plate.
b)
the IEC regulations: - magnetothermal differential switch (also known as ground fault interrupter) with In
= nominal value as stated on the rating plate; - Differential with Id sensitivity = 30 mA.
Operator's guide
. Keep the ventilation grills free from obstruction for at least 30 cm.
Cut the strap and lift up the cardboard package.
3.
4
Lift the appliance. . Remove the pallet or crate.
6
2.
Ensure that the supply socket has the following characteristics:
10. Replacing the internal lights
11. Replacing the door's magnetic gasket
Maintenance manual (Page 48):
1. Cleaning the condenser
2. Cleaning the evaporator
3. Glass panel
4. Wiring diagram diagram of refrigeration unit
9
13
. If the appliance is not working and unused, it is
14.
Do not keep the neon light up if the refrigeration
2.
Insert the forks of a forklift truck between appliance
5
. Place the appliance on a flat
2
. Fix the handle base to the door frame using
3
2
6
2
3
7
11
.Ensure that
12
. If damp air or products
WOODEN CRATE 1b
7
2.
First
2
(A)
attached
a) it is properly
It complies with
c)