Ryobi P790 Manual Del Operador página 6

INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 8.
 Insert the battery pack into the product as shown.
 Make sure the latches on each side of the battery pack
snap into place and the battery pack is secured before
beginning operation.
 Depress the latches to remove the battery pack.
For complete charging instructions, refer to the Operator's
Manuals for your battery pack and charger models.
WARNING:
Always remove battery pack or unplug extension cord
from the product when you are assembling parts, mak-
ing adjustments, cleaning, or when not in use. Remov-
ing battery pack and unplugging the extension cord will
prevent accidental starting that could cause serious
personal injury.
INSTALLING/REMOVING POWER CORD
See Figure 2, page 8.
WARNING:
Do not route cord under carpets, rugs, runners, furniture,
or appliances and always route cord away from traffic
areas to prevent a tripping hazard.
 Remove the battery pack.
 Insert the female end of the power cord into the product
as shown.
 Connect the male end of the power cord to the power
source.
 Make sure the power cord is secured before beginning
operation.
WARNING:
Keep light away from combustible materials. If wrapped
or in contact with fabrics, the lens can produce sufficient
heat to melt some fabrics. To avoid serious personal
injury, never allow the lens to come in contact with
anything.
MAGTRAY
™
The MAGTRAY , located on the base of the light, conveniently
™
stores screws or other small parts.
OPERATION
POWER BUTTON
See Figure 3, page 8.
The light will be in the OFF position until the power button
is pressed.
 Connect the product to an AC or DC power supply.
 Press and release the power button three times to cycle
through high, medium, and low brightness levels.
 Press and release the power button a fourth time to turn
the light OFF.
NOTE: This light is equipped with a low voltage indicator. If
the light flashes 3 times while a battery pack is installed, this
indicates a low charge condition. Three additional flashes
indicate that shutdown will follow quickly. Install a charged
battery pack and resume operation.
ADJUSTABLE HEAD
See Figure 4, page 8.
CAUTION:
Do not place hands or fingers between adjustable head
and frame when positioning light to avoid pinching your
fingers or hands.
The light head can rotated vertically 180°. It can be rotated
clockwise or counterclockwise 180°.
HANGING THE LIGHT
See Figure 5, page 8.
WARNING:
Only hang or mount LED light in an area where no
electrical wires, utility cables, pipes, or other obstructions
are located. Contact your local utility company or a
qualified electrician if you are unsure. Do not hang light
from any electrical power cord. Ensure light is securely
installed to prevent falling object hazard. Failure to follow
these instructions can result in electrocution, electrical
shock, or other serious personal injury.
 The light can be hung by its hook.
NOTE: Be careful not to hang the light in such a way
that it prevents normal operation or damages the cord.
 The hook allows for for additional hanging options. Twist
the free end into the keyhole on top of the light. Pull the
hook upward and hang in the desired location. To close
the hook, place the open end in the hole and push until
it clicks into place.
 You may use a screw to secure the light in place. Do
not overtighten.
6 – English