Installation Guide For Suspended Ceilings - Tannoy CVS 4 Micro Manual De Instrucciones

Ocultar thumbs Ver también para CVS 4 Micro:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

6.1. Installation Guide for Suspended Ceilings

1. Remove the ceiling tile from its frame and place it on a flat
surface. Mark the cut-out area on the ceiling tile by tracing
around the template provided. (Fig.1)
2. Cut out the hole in the ceiling tile using a pad saw. (Fig.2)
3. Place the C-Ring and tile-bridge on top of the ceiling panel,
aligning the C-Ring over the hole, and screw the C-Ring to the
tile bridge using the fixings provided. (Fig.3)
4. Slide the speaker assembly through the hole and turn the
screws on the front of the speaker to extend the mounting wings.
Tighten the screws until a firm grip is achieved. If using a power
driver, Tannoy recommends a torque setting of 1.5 Nm. (Fig.4)
DO NOT OVERTIGHTEN!
5. Slide the tile panel back into the suspended ceiling. The tile
bridge ends will catch over the railings, supporting the weight of
the speaker. (Fig.5)
6. Connect a secondary support line to safety tab. Some
construction codes require use of this secondary support point,
which should connect to a separate secure support point using a
suitable support line. Consult construction codes in your region.
Go to section 7 for instructions on wiring and set-up instructions.
6.1. Installation Guide for Suspended Ceilings
CVS 4 Micro (EN54) Operation Manual rev 1.1.1
Fig.1
Fig.2
Fig.3
Fig.4
Fig.5
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

En54

Tabla de contenido