DeWalt DXAEPS2 Manual De Instrucciones página 12

If the Jump Starter Power
Switch is rotated to the on
position and the clamps
are not connected to a
battery (refer to the "Jump
Starter" section) ...
If the clamp connections
to the battery's positive
and negative terminals are
reversed (refer to the "Jump
Starter" section) ...
When the unit is charging
or recharging using
the built-in 120 Volt AC
Charger or the 12V DC
Charging Adapter (refer to
the "Charging/Recharging"
section) ...
DXAEPS2_ManualENSP_101216.indd 12
... a two-second warning will
sound every 10 seconds. The
backlit LCD screen will display
the Battery Status Icon, Battery
Voltage Indicator, the Clamp Icons,
and the "+" and "–" signs. The
Alarm Icon and the Jump Starter
Icon will flash. The unit remains
on until the Jump Starter Power
Switch is switched off and then
displays the battery status icon
and the voltage of digital display
for 10 seconds before automatic
shut down.
... the backlit LCD screen will
display the Battery Status Icon,
Battery Voltage Indicator, and the
Clamp Icons. The Alarm Icon, the
"+" and "–" signs and the Reverse
Polarity Icons will flash and the unit
will sound a warning continuously
until the clamps are disconnected
from the battery.
... a beep will sound and the
backlight will turn on for 10
seconds (only). The LCD screen
will continue to display the Battery
Status Icon and Battery Voltage
Indicator. The bars on the Battery
Status Icon will change from empty
to solid (bottom to top) repeatedly.
NOTE: The unit will automatically power off once ALL the functions
and the charging process are turned off.
Viewing Battery Status
The Battery Status Icon and Battery Voltage Indicator indicate the
battery charge level as follows.
• If the battery charge level is at full capacity, four solid bars will display.
• If the battery is partially charged, two or three solid bars will display.
• If the battery is nearly empty, one solid bar will display. The unit should
be charged at this time.
• If the battery is completely empty, four blank bars will display. The
unit MUST be charged at this time or the unit's built-in low voltage
protection will activate. The empty Battery Status Icon will flash for
a short period of time before automatic shut down. The unit will not
operate until the battery is recharged.
Charging/Recharging
Lead-acid batteries require routine maintenance to ensure a full charge
and long battery life. All batteries lose energy from self-discharge over
time and more rapidly at higher temperatures. Therefore, batteries need
periodic charging to replace energy lost through self-discharge. When
the unit is not in frequent use, manufacturer recommends the battery
should be recharged at least every 30 days and after each use.
12
10/19/2016 3:56:34 PM