Analog Thermostat - BERG PROFESSIONAL Serie Manual De Instrucciones

3.2.1 Analog Thermostat

ONLY REFRIGERATOR MODELS (Example: EDMT_EDST_EDUR)
Before you connect the unit to the power supply, verify the thermostat is NOT in the OFF
position (the position of the thermostat must be different than zero).If the thermostat is in the
OFF position, the compressor will not run. Keep in mind, the evaporator fan sand lights will still
have power while the thermostat is in the OFF position.
The knob of the thermostat is the temperature controller. This is located inside the cabinet.
Please be sure that the knob of thermostat is pointing to the yellow arrow (Figure # 3, See p.
iv).This position is recommended by the factory to assure correct function of the equipment (
Figure #1 See p. iv).
Note:
Keep in mind, if you move the knob to a different position that is recommend from factory, these
temperature will change, as well.
The knob position near the number one, gives you the warmest temperature and the knob
position near the number seven, gives you the coldest temperature.
FIGURE 1
2
Thermostat it´s located inside the unit in
.
1
3
the right side
1. For best performance knob
should be pointing yellow mark.
2. Position thermostat to zero,
compressor will not work.
3. Knob to adjust thermostat
settings.
4. Knob position in "# 1", for
warmest temperature, and Knob
position in "# 7" for coldest
temperature.
5