ABC Design Hazel Manual Del Usuario página 16

1. "Hazel" car seat
1. Seat
2. Padding on safety harness
3. Fastening on safety harness
4. Adjustment strap
5. Adjustable handle
6. Removable seat padding
7. Belt guide for three-point lap restraint
8. Release button for adjustable handle
9. Button for adjustment strap
1. Adjustable handle
2. Canopy
3. Belt guide for three-point chest strap
2. Strapping the baby in
Open belt buckle by pressing the red button on the buckle.
Lay your baby carefully in the seat.
The baby must be fully upright in the seat.
This is the most comfortable position.
Bring the ends of the two shoulder straps together until they overlap.
Insert the end fittings in the belt fastening until you hear them "CLICK" into place.
Tighten to fit by pulling on the loose end of the adjustment strap
3. Adjusting the safety harness
The harness should be adjusted to the size of your baby. The shoulder straps should pass through the
openings in the seat at about baby's shoulder height. Choose the required height of the shoulder straps and
pull the straps through the opening in the seat.
Loosening: Press the button (1) for the adjustment strap on the front and pull on both shoulder straps at
the same time.
Tightening: Pull on the loose end of the adjustment strap (2) until the harness is sufficiently tight. It is not
necessary to press the adjustment button.
Make sure that your baby is firmly and safely positioned in the seat and that the belt holding the baby car
seat in place is tightened. The belts must not be twisted.
EN - 11