Camera Installation - Extel WAPP-GI2S Manual Del Usuario

Note:
body. Please secure the Camera ID somewhere safe when you complete the settings.
4. Wi-Fi Setting
4a. Choose the appropriate WIFI router for your local network
BE sure to choose your local home Wi-Fi router of your local network in the
ADVANCED SETTING. The system will begin to count down and reboot the system. The
camera view will show on screen again after Wi-Fi setting has been updated.
Note:
1. Wi-Fi setting may fail if you leave the ethernet cable connected. Please remove the cable
after settings have been completed.
2. The camera will only accept SSID composed with English alphabet characters and arebic
numbers, non-English and special characters (!@#$%, etc) will not be accepted.
If camera fails to connect to the assigned Wi-Fi router,, you need to redo setting again by
using a pin object to hold down [Reset] for 5 seconds to reset the camera. LED will start

CAMERA INSTALLATION

1. Place the mounting bracket on the
mounting surface as a pattern to mark
the holes.
2. Drill the mounting holes and use the
wall plug screws to secure the bracket to
the wall.
3. Fasten the camera to the bracket using
the tapping screws.
4. Hang the camera and plate onto the
hanger screws. Arrange cable properly so
that it will not block pan/tile operation.
CFI EXTEL O'MOUV HD - 12/2014
GB2