Stiga PlayTheBest T8740 Manual Del Usaurio página 5

7. Screw U-support tube (#21) to Strut Tubes (#17) with two Screws
(#33) as shown in figure 5. Align holes in U-support with holes in
Strut Tubes and thread screw (#33) into hole in Strut Tube (#17)
tighten screws all the way but be careful not to over tighten. You
could strip threads on screws if you over tighten.
Note: Due to shipping requirements the hinge (#18) may be positioned as
shown in Detail A, you will have to rotate the hinge to the position shown
in Detail B. DO NOT unscrew the hinge, you can rotate the hinge
without unscrewing it from the table.
If you want to see a video on how to position hinge (#18) go to:
http://www.escaladesports.com/customer-service/videos.html
8. Attach Hinges (#18) to Strut Tubes (#17) as shown in figure 5,
Detail B. With hinge positioned as shown, align hole in hinge with
hole in Strut Tube and attach with ¼" Screw (#30), Plastic Washer
(#38) and Locknut (#34). Plastic Washer (#38) goes between Strut
Tube and Hinge. Tighten nut securely. Repeat for other Hinge.
CAUTION: Hinges must be positioned exactly as shown or
table will not operate correctly and could be damaged.
DO NOT take hinges off.
Figure 5
32
16
16
30
34
34
37
5
21
33
17
17
34
38
18
Hinge Assembly
5
9. Attach Linkages (#16) to Leg (#19) as shown in
figure 5. Pivot one Linkage (#16) up and pivot
Leg out from top and align hole in Linkage with
hole in Leg (#19). Attach Linkage (#16) to Leg
(#19) using Hex Head Bolt (#32), Spacer (#37)
and Locknut (#34). Spacer (#37) goes between
Linkage and Leg. Attach other Linkage to Leg the
same way. Tighten nuts securely.
10. With at least two adults, repeat steps 6
. through 9 for other table top assembly.
DO NOT OPEN THE TABLE TO PLAYING POSITION
UNTIL BOTH TOPS ARE INSTALLED! DO NOT LEAVE
TABLE STANDING UNATTENDED. IT COULD BE
KNOCKED OVER CAUSING SERIOUS BODILY INJURY
OR PROPERTY DAMAGE.
19
ATTENTION: If hinge is positioned as
32
shown below (Detail A), Rotate the hinge as
shown in Detail B. Do not take hinge off.
37
Spacer goes between
Linkage Arm (#16)
and Leg (#19)
16
CAUTION: Position
shown in Detail B or table will not operate
correctly and could be damaged.
33
30
38
position of hinge
18
Detail A
17
Shipping position
of hinge
Hinges exactly as
Detail B
30
38
34
17
18
Assembly
Plastic Washer goes
between Strut Tube
(#17) and Hinge (#18)