Cea Specifications; Amplifier Settings; Signal Input And Output Configurations; Input Gain - Orion Cobalt CO3002 Manual Del Usuario

CEA SPECIFICATIONS

CO3002
CO6002
HIGH LEVEL HARNESSES
Do not connect the high level input connections to power, signal, or chassis ground as damage
to the head-unit outputs may result. The high-level inputs are designed to work with either
grounded or BTL speaker level outputs (found on most head units).

AMPLIFIER SETTINGS

Signal Input and Output Configurations

The input section of the amplifier consists of a phase switch that sets the output configuration,
gain controls, and RCA inputs. The input section makes it easy to adapt this amplifier to most
system configurations.

Input Gain

The Orion Cobalt CO3002 and CO6002 amplifiers have level adjustments to allow for easy inte-
gration with any source unit. The input sensitivity can be adjusted from 175mV to 8V. Refer to
Testing the System and Adjusting the Sound of the System sections of this guide for detailed
instructions on setting the gain.
© 2012 MD Audio Engineering —all rights reserved
Power Output: 60 Watts RMS x 2 at 4 ohms and < 1% THD+N
Signal to Noise Ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 80 Watts RMS x 2 at 2 ohm and < 1% THD+N
Power Output: 100 Watts RMS x 2 at 4 ohms and < 1% THD+N
Signal to Noise Ratio: -75 dBA (reference Watt into 4 ohms)
Additional Power: 155 Watts RMS x 2 at 2 ohm and < 1% THD+N
HIGH LEVEL CONNECTIONS
WIRE COLOR
Black
White/Black
White
Gray/Black
Gray
INPUT CONNECTION
Ground
- Left channel
+ Left channel
- Right channel
+ Right channel
5