Liberty Pumps 230 Serie Manual De Instalación página 2

1.
General Information – All Models
Before Installation, read the following instructions carefully. Each Liberty pump is individually factory tested to assure
proper performance.
providing years of trouble-free service.
•
Risk of electric shock. Always disconnect the pump from the power source before handling or making adjustments.
•
The electrical connections and wiring for a pump installation should only be made by qualified personnel.
•
This pump is supplied with a grounding conductor and grounding-type attachment plug. To reduce the risk of electric
shock, be certain that it is connected only to a properly grounded, grounding-type 15 Amp receptacle.
•
Always wear rubber boots when water is on the floor and you must unplug the pump.
•
DO NOT bypass grounding wires or remove ground prong from attachment plugs.
•
DO NOT use an extension cord.
•
This pump requires a separate, properly fused and grounded branch circuit. Make sure the power source is properly
sized for the voltage and amperage requirements of the pump, as noted on the nameplate.
•
The electrical outlet shall be within the length limitations of the pump power cord, and at least 4 feet above floor level
to minimize possible hazards from flood conditions.
•
The installation must be in accordance with the National Electric Code, Uniform Plumbing Code, International
Plumbing Code, as well as all applicable local codes and ordinances.
•
Sump and sewage pumps often handle materials which could cause illness or disease. Wear adequate protective
clothing when working on a used pump or piping.
•
Never enter a pump basin after it has been used. Sewage and effluent can emit several gases which are poisonous.
•
Keep clear of suction and discharge openings. To prevent injury, never insert fingers into pump while it is plugged in.
•
DO NOT use this product for flammable or corrosive liquid.
•
DO NOT use this product in applications where human contact with the pumped fluid is common (such as swimming
pools, fountains, etc.)
•
NEVER dispose of materials such as paint thinner or other chemicals down drains, as they can chemically attack and
damage pump components, potentially causing product malfunction or failure.
•
DO NOT use pumps in water over 140°F (60°C).
•
DO NOT use pumps in mud, sand, cement, oil or chemicals.
•
DO NOT modify the pump in any way.
•
DO NOT lift or carry pump by power cord.
•
DO NOT remove any tags from pump or cords.
•
If pump is installed during construction before power is available, it must be protected from the environment to prevent
water from entering through the cord plug end, etc.
Tools Required:
- Pipe wrench
- Regular screw driver
-
Hacksaw (For replacement or removal of existing rigid piping.)
By closely following these instructions, potential operating problems should be eliminated,
©Copyright 2008 Liberty Pumps Inc. All rights reserved - 2 -