Manuales relacionados para TORTU TT211INC-S
Resumen de contenidos para TORTU TT211INC-S
- Página 1 INOX Wall-Mount Single-Lever Basin Mixer INOX Rough-In Valve for Wall-Mount Basin Mixer Installation Guide - Guida D’installazione - Guia de Instalacion - Guide D’installation TT211INC-S TT811RSA-S...
-
Página 2: Installation Requirements
Attention – Before Installation Inspect this product to ensure you have all parts as shown that are required for proper installation. The valve cartridge has been factory tested and adjusted – DO NOT TAKE THE CARTRIDGE APART. Taking the cartridge apart will void the warranty. Ensure that both hot and cold water feeds are properly connected to the marked lav connecting. - Página 3 1¾" 1½" 1½" [43] [32] [35] 5½" Ø1¾" [136.6] [45] 1½" [36] 1¼" [30] ¼" 1½" [35] 5½" [139] 1½" 4" [35] [104] 5½" [136.6] 2" [50] 1¼" [30] 2" [49] 3" [74]...
- Página 4 5½" [139] 1½" 4" [35] [104] 5½" [136.6] 2" ATTENTION [50] VERY IMPORTANT PLACE THE ROUGH-IN WITH THE MEASURES INDICATED 1¼" [30] 2" [49] 3" [74] EN - INSTALLATION GUIDE Place the rough In on the wall, respecting the measurement indicated previously. At the time of fixing, check that the rough-in part is perfectly level.
- Página 5 EN - INSTALLATION GUIDE Remove the plastic cover with the knife cutting the plastic flush with the wall. Position the ring (1) on the wall. Insert the handle (2). Tighten the grub screw (3) using a Allen key (4). Screw the lever (5) onto the handle. The lever (5) must be downwards.
- Página 6 EN - MAINTENANCE Unscrew the lever (1) and the grub screw (2) using the supplied allen wrench (3). Remove the handle (4). Unscrew the ring nut (5) using the supplied key (6). Replace the cartridge (7) paying attention the reffering pivots on the base of the cartridge are correctly set in the corresponding seat inside the tap body (8).
- Página 7 TT211INC-S INLET EXIT COLD 1/2" GAS 1/2" GAS INLET 1/2" GAS 3" [74] 1½" [35] 5½" [139] 4" [104] 2" [50]...
- Página 8 TT811RSA-S ENCASING MINIMUM ENCASING 1½" [36]...