Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Before You Begin

Safety Notes

The Safety Notes include important laser system safety information. Read and understand all instructions
before powering on the laser for the first time. Knowing these safety instructions is crucial to avoiding laser
eye injury and breaking the law. Keep this User Manual in a safe place for future reference.
STOP AND READ ALL LASER SAFETY DATA
Lasers can be hazardous and have unique safety considerations. Permanent eye injury and
blindness are possible if lasers are used incorrectly. Pay close attention to each safety
REMARK and WARNING statement in this User Manual. Read all instructions carefully
BEFORE operating this device.
Always connect the product to a grounded circuit to avoid the risk of electrocution.
Always disconnect the product from the power source before cleaning.
Avoid direct eye exposure to the light source while the product is on.
Make sure the power cord is not crimped or damaged.
Never disconnect the product from power by pulling or tugging on the cord.
If mounting the product overhead, always secure to a fastening device using a safety cable.
Make sure there are no flammable materials close to the product when operating.
Do not touch the product's housing when operating because it may be very hot.
This product is not intended for permanent installation.
Always make sure that the voltage of the outlet to which you are connecting the product is
within the range stated on the decal or rear panel of the product.
The product is for indoor use only! (IP20) To prevent risk of fire or shock, do not expose the
product to rain or moisture.
Always install the product in a location with adequate ventilation, at least 20 in (50 cm) from
adjacent surfaces.
Be sure that no ventilation slots on the product's housing are blocked.
Never connect the product to a dimmer.
Make sure to replace the fuse with another of the same type and rating.
Always use the mounting bracket to carry the product.
Do not switch the product on/off in short intervals. This will reduce the laser diode life.
Do not shake this product. Avoid brute force when mounting or operating this product.
ALWAYS use a safety cable when mounting the product overhead.
The ambient operating temperature for the laser is 59 °F to 95 °F (15 °C to 35 °C). Do not
operate this product outside this range.
In the event of a serious operating problem, stop using the product immediately.
Never try to repair the product. Repairs carried out by unskilled people can lead to damage or
malfunction. Contact the nearest authorized technical assistance center.
CAUTION! Use of controls, adjustments, or procedures other than THOSE specified IN
THIS USER MANUAL may result in hazardous radiation exposure.
Avoid direct eye contact with laser light. Never intentionally expose your eyes or others to
direct laser light.
This laser product can potentially cause instant eye injury or blindness if laser light directly
strikes the eyes.
It is illegal and dangerous to shine this laser into audience areas, where the audience or other
personnel could get direct laser beams or bright reflections into their eyes.
It is a U.S. federal offense to shine any laser at aircraft.
To eliminate wear and improve its lifespan, during periods of non-use completely disconnect
from power via breaker or by unplugging it.
DO NOT attempt any repairs. Repairs and servicing must be carried out by a certified
technician. Unauthorized modifications are forbidden for safety reasons!
Keep this User Manual for future consultation. If transferring ownership of the product to
another user, be sure this document is kept with the laser.
Scorpion Dual RGB User Manual Rev. 3
Page 3 of 52

Publicidad

Tabla de contenido
loading

Tabla de contenido