Irc-6 Infrared Remote Control; Irc-6 Operation - Chauvet DJ Scorpion Dual RGB Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Operation

IRC-6 Infrared Remote Control

The Scorpion Dual RGB can be operated with the CHAUVET IRC-6. To enable IR wireless control, follow
the instructions below.
1. Press <MENU> repeatedly until rEN shows on the display.
2. Press <ENTER>.

IRC-6 Operation

Automatic Mode
To turn on Automatic mode with the IRC-6:
BLACK
AUTO
SOUND
OUT
Sound-Active Mode
To turn on Sound-Active mode with the IRC-6:
SENSI-
STROBE
SPEED
TIVITY
To adjust the sound sensitivity:
%
MANUAL
FADE
R
G
B
Manual Control
A
UV
W
To manually select the laser color with the IRC-6:
-
+
0
1
2
3
To manually select the laser pattern with the IRC-6:
4
5
6
7
8
9
Black Out
To black out the lasers with the IRC-6:
This will turn off all the lasers until the button is pressed again.
NOTE: The IRC-6 will not respond to any inputs when Black Out is activated. If the
product does not respond when a button is pressed, try pressing <BLACK OUT>.
Black Out may have been activated.
Any setting on the IRC-6 will be saved until the system is rebooted. The system will
revert to Auto Mode after reboot.
The buttons on the IRC-6 not listed above are reserved for future use.
Scorpion Dual RGB User Manual Rev. 3
1. Press <AUTO> on the IRC-6.
1. Press <SOUND> on the IRC-6.
1. Press <SENSITIVITY> on the IRC-6.
2. Press <+> or <–> to increase or decrease the sensitivity.
1. Press the desired color, from <R> (red), <G> (green), <B> (blue), <A>
(yellow), <UV/P> (magenta), or <W> (multi-color).
1. Select a manual color.
2. Press <+> or <–> to cycle through the patterns.
1. Press <BLACK OUT> on the IRC-6.
Page 13 of 52

Publicidad

Tabla de contenido
loading

Tabla de contenido