Technical Specifications; Electrical Wiring - Polar CB920 Manual De Instrucciones

Telephone Helpline: 0845 146 2887 (United Kingdom)
Fault
Ice cubes not fully
formed
Not producing
enough ice
Water comes
through curtain

Technical Specifications

Model Voltage
CB920 230V 50Hz
CB922 230V 50Hz
CB923 230V 50Hz

Electrical Wiring

This appliance is supplied with a 3 pin, moulded, BS1363 plug and lead, with a 13 amp fuse as standard.
The plug is to be connected to a suitable mains socket.
This appliance is wired as follows:
• Live wire (coloured brown) to terminal marked L
• Neutral wire (coloured blue) to terminal marked N
• Earth wire (coloured green/yellow) to terminal marked E
This appliance must be earthed, using a dedicated earthing circuit.
If in doubt consult a qualified electrician.
Electrical isolation points must be kept clear of any obstructions. In the event of any emergency
disconnection being required they must be readily accessible.
Probable Cause
Blocked nozzle
First ice making cycle
Ice melted
Spray bar dislodged/misaligned Reattach spray bar
Ambient temperature too high
Water pressure too low
Spray bar dislodged/misaligned Reattach spray bar
Power Current Storage
205W 0.9A
380W 1.65A
680W 2.95A
Clean nozzle jets
Use ice from second cycle
Do not leave ice in bin for extended periods
Reelect appliance to a suitable position
Check water inlet hose/inlet hose filter for
blockages
Bin Ice
Making Refrigerant
(kg) Capacity
9 25kg/hour
14 40kg/hour
20 60kg/hour
Action
Dimensions
h x w x d mm
R134a 800 x 400 x 495
200g
R134a 880 x 490 x 535
300g
R134a 930 x 560 x 570
420g
UK
Weight
(kg)
41
53
67
4