Maintenance & Care - Pfister SANTIAGO LG48 Serie Manual De Instrucciones

7
7B
HOT
7A
COLD
7 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (7A) to Faucet Inlets (7B). Hot water supply lines go into left
inlet. Cold water supply lines go into right inlet. (Supply lines are not included). Please
follow manufacturer's instructions when installing suppy lines.
8
8 POP-UP ROD CONNECTION
Insert Lift Rod (8A) into hole at the top of Spout (8B).
DRAIN BODY INSTALLATION
9
9A
9 POP-UP INSTALLATION
Install and adjust Pop-Up (9A) using separate instructions supplied with the Pop-Up
assembly.
ENGLISH
7B
7A
8A
8B
3
10
10 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
FAUCET FUNCTION
11
HOT
OPEN
11 VALVE FUNCTION
COLD valve: close-counterclockwise, open-clockwise; HOT valve: close-clockwise,
open-counterclockwise.
MAINTENANCE & CARE
12
12E
12D
12C
12 FLUSHING & AERATOR CLEANING
After installation is complete, remove Aerator Housing (12A). Turn Valves (12B) on
and allow both hot and cold water to run for at least one minute each. While water is
running, check for leaks. To clean the aerator, disassemble Aerator Housing (12A) by
separating the Aerator Shell (12C), Basket (12D), and Washer (12E). Once parts have
been cleaned, reassemble by reversing steps.
COLD
OPEN
12B
12A