Makita FS2200 Manual De Instrucciones página 5

Atornillador para tablaroca
Ocultar thumbs Ver también para FS2200:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Lighting up the lamps
1
009967
CAUTION:
Do not look in the light or see the source of light
directly.
To turn on the lamp, pull the trigger. Release the trigger
to turn it off.
NOTE:
Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
Reversing switch action
A
1
B
009962
CAUTION:
Always check the direction of rotation before operation.
Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
This tool has a reversing switch to change the direction
of rotation. Move the reversing switch lever to
the
position (A side) for clockwise rotation or
the
position (B side) for counterclockwise rotation.
Hook
1
009963
1. Lamp
1. Reversing
switch lever
1. Hook
5
The hook is convenient for temporarily hanging the tool.
ASSEMBLY
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the
tool.
Installing or removing the bit
To remove the bit, first remove the locator by pulling the
lock ring away from the gear housing.
1
2
009964
Grasp the bit with a pair of pliers and pull the bit out of
the magnetic bit holder. Sometimes, it helps to wiggle
the bit with the pliers as you pull.
To install the bit, push it firmly into the magnetic bit
holder. Then install the locator by pushing it firmly back
onto the gear housing.
2
3
010169
1. Lock ring
2. Gear housing
1. Locator
1
2. Bit
3. Gear housing

Publicidad

Tabla de contenido
loading

Tabla de contenido