Worx WT807 Manual Original página 12

Adjusting Wheel Guard
Note: Before any work on
the machine itself, remove
the battery pack. For work
with grinding or cutting
discs, the protection guard
must be mounted. Use
the correct type of disc
for your application. If the
power tool is intended
to perform cutting off
operations, a guard specific
for this operation must be
fitted.
The coded projection on the
wheel guard ensures that only
a guard that fits the machine
type can be mounted.
Open the clamping lever (13).
Place the wheel guard with
coded projection into the
coded groove on the spindle of
the machine head and rotate to
the required position (working
position).
To fasten the wheel guard,
close the clamping lever (13).
The closed side of the
wheel guard must always
point to the operator.
12
OPERATION
Using On/Off Switch
Hand Grip Areas
Rough Grinding
Warning! Never use a
cutting disc for
roughing.
Cutting
WARNING: Wheel Guard
For Cutting must be
assembled before performing
cutting off operations.
WORKING HINTS FOR YOUR
ANGLE GRINDER
1. Always start at no load to achieve maximum
speed then start working.
2. Do not force the disc to work faster, reducing the
Disc's moving speed means longer working time.
3. Always work with a 15-30 angle between disc and
workpiece. Larger angles will cut ridges into the
workpiece and affect the surface finish. Move the
angle grinder across and back and forth over the
workpiece.
4. When using a cutting disc never change the
cutting angle otherwise you will stall the disc
20V Cordless Brushless Angle Grinder
5. When cutting very hard material best results can
6. When using a diamond disc it will become very
7 . Always ensure the workpiece is firmly held or
MAINTENANCE
See Fig. D
Remove the battery before carrying out any
adjustment, servicing or maintenance.
There are no user serviceable parts in your power
tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always
store your power tool in a dry place. Keep the motor
ventilation slots clean. Keep all working controls free
of dust. Occasionally you may see sparks through the
ventilation slots. This is normal and will not damage
your power tool.
TROUBLESHOOTING
Although your new angle grinder is really very
simple to operate, if you do experience problems,
See Fig. E
please check the following:
1. If your grinder wheel wobbles or vibrates, check
See Fig. F
2. If there is any evidence that the wheel is
See Fig. G
3. If working on aluminum or a similar soft alloy,
See Fig. H
ENVIRONMENTAL
PROTECTION
and angle grinder motor or break the disc. When
cutting, only cut in the opposite direction to the
disc rotation. If you cut in the same direction as
the disc rotation the disc may push itself out of
the cut slot.
be achieved with a diamond disc.
hot. If this happens you will see a full ring of
sparks around the rotating disc. Stop cutting and
allow to cool at no load speed for 2-3 minutes.
clamped to prevent movement.
that outer flange is tight; check that the wheel is
correctly located on the flange plate.
damaged do not use as the damaged wheel may
disintegrate, remove it and replace with a new
wheel. Dispose of old wheels sensibly.
the wheel will soon become clogged and will not
grind effectively.
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
Local Authority or retailer for recycling advice.
EN