Operation - NORPOLE EWCIM350S Manual De Usuario

OPERATION

Note: If there is something wrong with the water supply system, the ice maker will restart
automatically in 24 hours. Otherwise, you will need to stop the ice maker and restart it.
Note: DO NOT remove the block water board while the ice maker is running.
Note: Never keep anything other than ice in the ice storage bin. Objects like wine and beer should not
be stored in the ice bin as these bottles are unsanitary and the labels may slip off and plug up the
drain.
1. Plug in the ice maker, turn on the switch and the run indicator light will illuminate.
2. When the ice maker is being used for the first time or reused after being left idle for a long time,
the first and second ice making cycles are meant to clean the tube system; DO NOT use this ice.
After the water is drained, the normal ice making procedures can begin.
3. All of the functions – water inlet, ice making, ice dropping and ice storing - are controlled
automatically for continuous ice-making.
4. If the ice storage bin is full, the ice full indicator light will illuminate and the ice maker will stop
automatically. If there is a water shortage or something wrong with the water supply system, the
water low indicator light will illuminate and the ice maker will stop operation. The ice maker will
restart automatically in 24 hours. Otherwise, you will need to stop the unit and restart it again.
5. Use potable water as a water source. If the water low indicator light is illuminated and no ice is
being made when the ice maker begins, there may be air in the water inlet tube. If the hydraulic
pressure is low, after 5 minutes, the machine will add water automatically. The water low indicator
light will turn off when the water is full and the ice maker will begin operating.
EN - 9
9