Everyday Maintenance; Operating Faults - Eurocave Pure Serie Modo De Empleo

7 - E
Your EuroCave cabinet is a tried and tested appliance.
Maintenance operations to be carried out approximately once a year
•
Unplug and unload the appliance.
•
Regularly vacuum the condenser at the back of the appliance.
•
Clean the inside of the compartments with water and a gentle cleaning product.
•
Rinse thoroughly.
•
Replace the active charcoal filter in the breather hole at the top of your cabinet
•
Remove the charcoal filter manually. It is available from your usual retailer. It must be replaced by
an original manufacturer's part.
•
Check that the seals are in good condition.
Maintenance of the optional extra "Premium" equipment:
•
Clean the light strip with a microfibre or soft cloth only.
•
To remove text, written using the white marker pen, from the bottle identification supports
("premium" equipment), use a damp cloth.
•
To clean the fronts of the shelves:
- use a microfibre or soft cloth only
- only use water or a cleaning product designed for glass
Never use cleaning products containing acetone, spirit or alcohol, white
spirit or synthetic thinners which could damage the front of the shelf.
Stainless steel:
•
To clean the stainless steel surface, we recommend a neutral liquid soap solution.
•
Make sure that the soap does not contain abrasive additives that might harm the finish.
•
Apply solution with a soft cloth.
•
The cloth should not have any buttons, zips etc. that might scratch the stainless steel.
•
Rub the surface following the brushed direction.
•
Dry with a soft clean cloth following the brushed direction.
Never pour liquid directly onto the stainless steel. Never use chemical solvents, abrasives or granular cleaners, petrol or alcohol,
all of which could harm the cabinet surface. No chlorine-based products.
8 - O
Possible incidents
The pictogram is displaying
The pictogram is still displaying
even though I have taken the corrective
actions above
The pictogram is displaying
The pictogram is flashing
The appliance cannot lower the level of
humidity to the desired value
The pictogram is displaying
The pictogram is displaying
If your appliance does not seem to be working correctly, contact your EuroCave retailer.
18
GB
VERYDAY MAINTENANCE
PERATING FAULTS
Causes
The temperature has
not returned to within
the ±4 °C threshold
Operating fault
Open door alarm
The level of relative
humidity has been <
50 % for over 72 hrs
Charcoal filter alarm
Temperature sensor
fault alarm
Corrective actions
Check that the door is correctly closed.
Check the condition of the door seal.
If you placed a large amount of bottles in your cabinet in the last few hours,
wait a while then check again. If the alarm is still displaying, contact your
EuroCave retailer.
Unplug the cabinet and contact your EuroCave retailer.
Make sure that the door is correctly closed.
• Pour a glass of water into the duct of the tray (see chapter 7, § IV).
• In order to know how often to add water, count the number of days
separating the 1st day you added water and the day when the pictogram was
displayed
After a few hours, the pictogram will disappear.
• Empty the cabinet, remove the humidity cartridge and clean the tray.
• Remove the tube placed at the back of the tray. The humidity will be directly
discharged out of the appliance.
Call the EuroCave retailer if the problem persists despite having carried out
these different operations.
Replace the charcoal filter (see chapter 4).
Contact your EuroCave retailer.