Cleaning Instructions - brentwood H-C1601 Instrucciones De Operación Y Seguridad

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

replace your outlet.
DO NOT defeat the safety purpose of the polarized plug.
CAUTION: TO PREVENT ELECTRIC SHOCK MATCH WIDE BLADE OF PLUG TO
WIDE SLOT, FULLY INSERT
OPERATING INSTRUCTIONS
Choose Your Power Setting:
1.
Power Control Switch Settings:
II HIGH: 1500 watts, I LOW: 750 watts, FAN ONLY (no heat), 0 OFF NOTE:
The HIGH setting can be used to warm the room quickly; when a
comfort level has been reached, the LOW setting can then be used to
conserve electricity.
Set the Thermostat (for use with HIGH and LOW power settings) or use the
2.
Fan:
Setting the Thermostat:
Turn the Temperature Control Switch clockwise, to the highest setting.
a.
When the desired room temperature is reached, slowly rotate the
b.
temperature Control Switch counter-clockwise until the heater turns
off automatically.
NOTE: Your heater will now turn on and off automatically to maintain the
desired room temperature.
Fan:
Turn the Power Control Switch to the FAN ONLY setting.
a.
Turn the Temperature Control Switch clockwise, to the highest
b.
setting, or to the point at which the fan turns on to maintain the
current temperature.
NOTE: Although the Fan operates off of the thermostat, no heat will be
generated when the Power Control Switch is in the FAN ONLY position.

Cleaning Instructions:

PRE-CLEANING INSTRUCTIONS
Turn the Power Control Switch to the '0' position.
1.
Disconnect the power cord from the electrical outlet.
2.
WARNING: Do not expose the heating elements or switches to water,
cleaning liquids or other chemicals, as fire, electrical shock, personal injury
and properly damage can occur.
CAUTION: Do not use gasoline, benzene or thinner to clean your heater, as
these chemicals can cause surface damage.
CLEANING AND MAINTENANCE
Use a vacuum cleaner with a crevice tool to remove dust from the interior
1.
or your heater.
Use a clean, soft and lightly damp cloth to gently wipe the surface of the
2.
enclosure.
Allow the enclosure to dry completely prior to operating your heater.
3.
5

Publicidad

Tabla de contenido
loading

Tabla de contenido