Husqvarna 7021P Manual De Operario página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

The operation of any lawn mower can result in foreign objects thrown into the eyes,
which can result in severe eye damage. Always wear safety glasses or eye shields
while operating your lawn mower or performing any adjustments or repairs. We
recommend standard safety glasses or a wide vision safety mask over spectacles.
HOW TO USE YOUR LAWN MOWER
ENGINE SPEED
The engine speed was set at the factory for optimum per-
formance. Speed is not adjustable.
ENGINE ZONE CONTROL
CAUTION: Federal regulations require
an engine control to be installed on this
lawn mower in order to minimize the risk
of blade contact injury. Do not un der
any cir cum stanc es attempt to defeat
the function of the operator control. The
blade turns when the engine is running.
Your lawn mower is equipped with an operator pres-
ence control bar which requires the operator to be
positioned behind the lawn mower handle to start and
operate the lawn mower.
TO ADJUST CUTTING HEIGHT (See Fig. 4)
Raise wheels for low cut and lower wheels for high cut,
adjust cutting height to suit your requirements. Me di um
position is best for most lawns.
To change cutting height, squeeze adjuster lever to ward
wheel. Move wheel up or down to suit your re quire-
ments. Be sure all wheels are in the same setting.
NOTE: Adjuster is properly positioned when plate tab inserts
into hole in lever. Also, 9-position adjusters (if so equipped)
allow lever to be positioned between the plate tabs.
ROTATE LEVER BACKWARD
TO LOWER MOWER
ROTATE LEVER FORWARD TO RAISE MOWER
TO CONVERT MOWER
Your lawn mower was shipped ready to be used as a
mulcher. To convert to bagging or discharging:
REAR BAGGING (See Fig. 5)
Lift rear door of the lawn mower and place the grass
catcher frame hooks onto the door pivot pins.
To convert to mulching or dis charg ing operation,
remove grass catch er and close rear door.
OPERATION
PLATE
TAB
LEVER
FIG. 4
PIVOT PINS
CATCH ER FRAME HOOK
SIDE DISCHARGING (See Fig. 6)
Rear door must be closed.
Open mulcher door and install dis charge deflector
under door as shown.
Mower is now ready for discharging operation.
To convert to mulching or bagging operation, dis charge
deflector must be removed and mulcher door must be
closed.
OPEN
MULCHER
DOOR
MOWER IS NOW
READY FOR
DISCHARGING
OPERATION
7
Use ear pro-
t e c t o r s
avoid damage
to hearing.
REAR
DOOR
GRASS
CATCHER
HANDLE
FIG. 5
INSTALL
DISCHARGE
DEFLECTOR
FIG. 6
t o

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

961330005

Tabla de contenido