Optional Accessory - Makita DHR182 Manual De Instrucciones

Dust cup set

Optional accessory

Installing the dust cup set
NOTICE:
If you purchase the dust cup set as
optional accessory, the standard side grip cannot
be used with the dust cup set being installed on
the tool. When the dust cup set is installed on the
tool, remove the grip from the standard side grip, and
then attach it to the optional grip base set.
1
1
2
2
► 1. Bolt 2. Grip 3. Optional grip base set
NOTICE:
Do not use the dust cup set when drill-
ing in metal or similar. It may damage the dust cup
set due to the heat produced by small metal dust or
similar. Do not install or remove the dust cup set with
the drill bit installed in the tool. It may damage the
dust cup set and cause dust leak.
Before installing the dust cup set, remove the bit from
the tool if installed.
3
3
3
11 ENGLISH
1. Install the spacer so that the grooves on the
spacer fit in the protrusions on the tool barrel while wid-
ening it. Be careful for the spring not to come off from
the slit of spacer.
► 1. Spacer 2. Spring
2.
Install the side grip (optional grip base set and
the grip removed from standard side grip) so that the
groove on the grip fit in the protrusion on the spacer.
Turn the grip clockwise to secure it.
► 1. Side grip
1
2
1