Bosch PS130 Instrucciones De Funcionamiento Y Seguridad página 11

2610056735 02-21 PS130_BM 2610015935 02-12.qxp 2/15/21 10:23 AM Page 11
DRILL/HAMMER DRILL/DRIVING
MODE SELECTOR RING
The mode selector ring allows the tool to be
set for various drilling/hammer drilling and
driving applications. Rotate the selector ring
right or left depending on the below
applications (Fig. 4).
Driving action: The driving position allows
operation of adjustable clutch for driving
screws and running nuts and bolts.
Drill only action: For drilling in woods,
metals, plastics or other non concrete
materials. The drill position overrides the
clutch for drilling.
Drill with hammer action: For drilling in
concrete, asphalt, tile or other similar hard
materials. The hammer drill position
overrides the clutch for hammer drilling.
ADJUSTABLE CLUTCH
Your tool features 20 clutch settings. Output
torque will increase as the clutch ring, is
rotated from 1 to 20 (Fig. 5).
Attention: The adjustable clutch will only
operate when mode selector ring is in the
driving position.
FIG. 4
Min.
GEAR SHIFTING
Your tool is equipped with two separate gear
ranges, low gear and high gear. Low gear
provides high-torque and slower drilling
speeds for heavy duty work or for driving
screws. High gear provides faster speeds for
drilling lighter work. To change speeds slide
switch, to the high or low position (Fig. 6).
ATTENTION: If your tool appears to be
running, but the chuck will not turn, check
to make sure the gear shifting switch is
pushed fully into desired setting.
When the trigger switch is released it
activates the brake to stop the chuck
quickly. This is especially useful in the
repetitive driving and removal of screws.
AUTOLOCK™
Your tool is equipped with an automatic
locking system. This feature will lock the bit
holder in one position when the trigger switch
is released. This will allow you to tighten or
loosen a nut or screw by rotating the tool by
hand with the switch off. This is convenient
when higher turning torque is needed.
BUILT IN WORK LIGHT
Your tool is also equipped with a light that
turns on automatically when the switch is
activated, for better visibility when
drilling/driving (Fig. 1).
-11-
FIG. 5
Max.
FIG. 6
BRAKE