Corner; Recess - WET Style BC 0102 Guia De Instalacion

DROP-IN CORNER
Left - Models: BC 0504, and BC 0904.
Right - Models: BC 0505 and BC 0905.
DROP-IN RECESS
Models: BC 0506, and BC 0906.
*
Using a blanket, cardboard, or other clean protective surface, turn the unit on its side so that
3
the unit is properly supported during drain installation.
Install the basic plumbing components: water inlet and floor drain. These tub models require a
4
vertical plumbing connection from the floor.
Plug & Bathe
TM
Overflow is pre-installed at the factory .
Clean the drain hole area in preparation of setting the drain. The area should be dry and free
of any debris. Apply a bead of clear silicone or plumber's putty around the Drain Body and
pass it through the drain hole. Apply plumber's putty to the Washer and slide it over the
bottom of the Drain Body. Please refer to P.4 of this installation guide for pictures.
P. 10
MODEL
BC 0506
BC 0906
The dimensions in the table do not include the gypsum plasterboard or cement panels.
* The dimensions in column B may vary depending on customer preferences.
Those indicated above represent the width of the bathtubs, plus 5".
3
connection system with slot design overflow and soft toe touch drain installation
MODEL
BC 05
BC 09 52-1/2"
The dimensions in the table are the minimums required
to enable installation of the tub. They may vary based
on customer requirements.
A B
72-1/4" 45"
60-1/4" 35"
Montréal - Canada | 1-888-536-9001 | www.wetstyle.com | November 2019
Installation guide
A B
60" 28"
25"
C D
*
20-1/8" 36-1/8"
16-1/8" 30-1/8"