WET Style BC 0102 Guia De Instalacion página 7

Installation guide
Bathtub installation - RECESS
Models: BC 0106, BC 0206, BC 0306, BC 0406, BC 1006, BC 1106, BC 1206 and BC 1406.
Decide exactly where you wish to install the bathtub. Build the partitions depending on the
1
bathtub model chose. For inner partition dimensions see the table on the previous page.
Clean, level and prepare the floor for installation.
Using a blanket, cardboard, or other clean protective surface, turn the unit on its side so that
2
the unit is properly supported during drain installation.
1
Install the basic plumbing components: water inlet and floor drain. These tub models require a
3
vertical plumbing connection from the floor.
Plug & Bathe
TM
Overflow is pre-installed at the factory.
Clean the drain hole area in preparation of setting the drain. The area should be dry and free
of any debris. Apply a bead of clear silicone or plumber's putty around the Drain Body and
pass it through the drain hole. Apply plumber's putty to the Washer and slide it over the
bottom of the Drain Body.
3
Montréal - Canada | 1-888-536-9001 | www.wetstyle.com | November 2019
connection system with slot design overflow and soft toe touch drain installation
PUTTY
or
SILICONE
2
WETSTYLE Plug & Bathe overflow and
drain connection system includes:
Soft-touch pop-up drain, for built-in
overflow. Fits both 1-3/4" tubular brass.
Washer
1-1/2" ABS Direct vertical drain waste
fitting (copper/brass option also
available).
ABS
PIPE
1-1/2" ABS 90º Elbow drain waste fitting
GLUE
(copper/brass option also available).
TM
P. 7