Cleaning And Maintenance - RST OP-ALFT3755-VEN Instrucciones De Ensamblado

Each installation site for any unit presents its own unique combustion environment. Specific factors
such as weather, wind currents, yard debris, altitude, drafts, the size of the surrounding area, all have
an influence on the proper operation of the unit. A normally operating unit will demonstrate the
following characteristics:
• A lively, realistic flame
• That is odor-free
If the flame is not clean (identifiable by excessive sooting on the decorative media), refer to the
CLEANING AND MAINTENANCE section below.
• Always purchase the correct size and grade of battery most suitable for the intended use.
• Clean the battery contacts and those of the device prior to battery installation.
• Ensure the batteries are installed correctly with regard to polarity (+ and -)
• Remove batteries from equipment when it is not to be used for an extended period of time.
• Remove used batteries promptly.
1. Always shut off the gas to the unit while performing service work.
2. Allow the unit to cool before servicing.
3. The unit should be inspected regularly. Excessive debris can build up on this unit from leaves,
dirt, or other debris. It is critical that all control components, burners, and the surrounding
area be kept clean and free of all obstructions.
4. KEEP THE SURROUNDING AREA AT THE BASE OF THE UNIT CLEAN AND FREE OF
OBSTRUCTIONS AT ALL TIMES.
5. The burner assembly must be replaced prior to the unit being put into operation if it is
evident that the burner is damaged. Contact your local dealer for replacement parts.
6. Periodically perform visual checks of the burner flames. The burner flames should be blue at
the base with a combination of blue/yellow at the body and tips. Contact a qualified service
person for maintenance.
CAUTION: HOT DURING OPERATION AND AFTER USE. Children must be supervised when in the
vicinity of this appliance. Serious injury may occur! Children must be alerted to the hazard of high
surface temperatures and should stay away to avoid burns or clothing ignition.
Keep entire area (around bottom) clear for proper vetting.
Date:
Model #:
Serial #:
Inspector #:
OPERATION
BATTERIES

CLEANING AND MAINTENANCE

QUALITY CHECK
20