Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
Polishing operation by sponge pad
CAUTION:
•
Always wear safety glasses or a face shield during
operation.
In general, keep the sponge pad at an angle of about 15
degrees to the workpiece surface.
Polishing operation by wool bonnet
CAUTION:
•
Always wear safety glasses or a face shield during
operation.
Hold the tool firmly. Turn the tool on and then apply the
wool bonnet to the workpiece.
In general, keep the wool bonnet at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to wool bonnet.
Sanding operation
003479
003480
15
003421
15
CAUTION:
•
Always wear safety goggles or a face shield during
operation.
•
Never switch on the tool when it is in contact with
the workpiece, it may cause an injury to operator.
•
Never run the tool without the abrasive disc. You
may seriously damage the pad.
Hold the tool firmly. Turn the tool on and then apply the
abrasive disc to the workpiece.
In general, keep the abrasive disc at an angle of about 15
degrees to the workpiece surface.
Apply slight pressure only. Excessive pressure will result
in poor performance and premature wear to abrasive
disc.
MAINTENANCE
CAUTION:
•
Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Replacing carbon brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark. Keep
the carbon brushes clean and free to slip in the holders.
Both carbon brushes should be replaced at the same
time. Use only identical carbon brushes.
Use a screwdriver to remove the brush holder caps. Take
out the worn carbon brushes, insert the new ones and
secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be per-
formed by Makita Authorized or Factory Service Centers,
always using Makita replacement parts.
7
001145
1. Limit mark
1
003423
1. Brush holder
1
cap
2
2. Screwdriver
Publicidad
Tabla de contenido
