Truper LIRO-5N Manual De Instrucciones página 19

Start up
This sander was designed to sand wood, metal, plastic
and similar materials. Can be used for repetitive sanding
jobs and finishing. Due to its size, is ideal for final jobs.
Dust Extraction
• Before connecting the tool to the power supply, adjust
the dust collecting container into the dust extraction duct in
the rear or the sander (E).
• For optimum dust extraction, remove and empty the
container when it is half-full and disassemble it to clean the
filter.
• Use the container when sanding wood. Do no use when
sanding metal. The metal particles could ignite the residual
wood dust or the inner pouch.
• Make sure to regularly clean the dust accumulated in the
container and the Velcro base.
Filter
E
Sander Operation
• Switch on the sander before setting it onto the work
piece.
• Keep the sander base parallel to the work piece surface.
• Press lightly downwards onto the work piece. Make
circular movements. Be sure the full sanding area is
supported on the work piece.
• Ensure the pressure is moderated. Do not force the
sander. Make it work at a reasonable speed. If too much
pressure is applied, the motor speed could be slower due
to overheating. It could cause insufficient sanding and
damage to the motor.
• If after sanding, the surface is still showing marks, sand
again with a coarser grain to eliminate the marks. Replace
the sanding disc with the next one and finish sanding. Or,
replace the worn sanding disc with a new one.
• Do not let the sanding disc be totally worn out. Replace it
before this happens.
7
ENGLISH