Basic Operations; Silent Mode - Yealink W53P Guia De Inicio Rapido

E
DNS address for the base station manually.
N
G
To configure the network parameters for the base station manually:
L
I
1. Press the OK key to enter the main menu, and then select Settings->System
Settings ->Network (default PIN: 0000)->Basic.
S
H
2. Select the desired IP address mode from the IP Mode field.
3. Press to select the corresponding IP address mode.
4. Make the desired changes.
5. Press the Save soft key to accept the change.
Note:
• The IP DECT phone supports either or both IPv4 and IPv6 addresses modes, but IPv6
is disabled by default.
• Wrong network settings may result in inaccessibility of your DECT phone may affect
the network performance. Contact your system administrator for the network
parameters.

Basic Operations

Turning Handset On/Off
To turn the handset on, do one of the following:
• Press , then the LCD screen lights up.
• Place the handset in the charger cradle. The handset will be turned on automatically.
To turn the handset off:
Long press
Locking/Unlocking Keypad
• Long press
• Long press

Silent Mode

• Long press
• Long press
6
to turn the handset off.
when the handset is idle to lock the keypad.
again to unlock the keypad.
when the handset is idle to switch the silent mode to On.
again to switch the silent mode to Off.