Setting The User Code; Mounting Method - First Alert 1037293 Manual Del Usario

Setting The User Code

CLOSING DOOR
Turn the handle(knob) counter clockwise to close the door.
1
AUTOMATIC LOCK OUT PERIOD
For added security, the safe will automatically lock out entry if the wrong
password is entered multiple times
3 continuously wrong entries will activate the warning beep for 20 seconds.
1
6 continuously wrong entries will activate the warning beep for 5 minutes.
2
CAUTION
The key pad would be disabled during the beeping. You can only stop the beeps by
opening the safe with emergency key and cut power by removing the batteries.
SETTING THE USER CODE
With the door open, press the reset button once, start setting code when the
1
yellow light goes on.
Input new code (3-8 digits), and press " * " or "#" button to confirm with 2
2
buzzer beeps, which indicates the acceptance and storage of the new code.
If the yellow light flashes with 3 buzzer beeps, the code changing is not
3
effective and you need to try again.
SETTING MASTER CODE
Open the safe, input "0" twice and press reset button, start setting code
1
when the yellow light goes on.
Input the new master code (3-8 digits), then press " * " or "#" button to
2
confirm, it will be confirmed by 2 buzzer beeps and the yellow light flashes
two times, then setting is done successfully.
If the yellow light flashes three times, it means the new code is
3
invalid and should be reset again.
NOTE: The user code is the code that will be used most often, the master code
can be used as a back up code. For example, if the user changes the user code,
the master code will allow the safe to be opened. Write down both codes and
keep in a safe place. You can change both master and user codes.
5
OPENING THE SAFE WITH THE EMERGENCY KEY
Upon first receipt of the safe, if keypad is not functioning, the user code is
unknown, you can use the emergency key to open the safe.
Remove the cover of the emergency lock.
1
Insert the emergency key, turn it counter clockwise, then
2
turn the handle(knob) clockwise to open the door.

MOUNTING METHOD

Fix the safe in the place so it is not easy to move.
Drill holes for expansion bolts in the right place.
1
Use the expansion bolts to secure the case to the wall.
2
Turn the expansion bolts counter clockwise to separate.
3
Make sure the case is mounted in place as required and then tighten
4
all screws.
CAUTION
Use the expansion bolt when there is a concrete wall surface. Use the clamping
screw when there is a wooden wall surface.
A
Shelf
Mounting Method
B
Shelf Shelf
6