Danby DPF073C2WDB Manual Del Propietário página 6

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any length
of time during this process, it must be allowed to remain
upright for 6 hours before plugging it in to avoid damage
to the internal components.
1. Remove the lower hinge from the right side of the
cabinet.
2. Remove the refrigerator door. Move the bushing from
the top right side to the top left side of the refrigerator
door.
3. Remove the door stop from the bottom of the
refrigerator door.
4. Install the door stop on the bottom left side of the
refrigerator door.
5. Remove the screws from the center hinge. Remove the
center hinge and the hinge spacer. Remove the freezer
door.
6. Remove the center hinge screw hole plugs and install
them in the screw holes on the right side of the cabinet.
7. Remove the screw covers and the screws from the top
cover and then remove the top cover. Remove the upper
hinge from the top right side of the cabinet. Move the
hinge pin to the opposite side of the upper hinge. Install
the upper hinge on the top left side of the cabinet.
Install the top cover and the screw covers on top of the
cabinet. Install the left door stop on the bottom left side
of the freezer door. Install the freezer door.
8. Install the center hinge. Ensure that the center hinge
spacer is installed with the center hinge as the spacer
is necessary to allow the doors to have full range of
motion. Install the refrigerator door.
9. Install the lower hinge on the left side of the cabinet.
A. Lower Hinge
B. Screws
C. Bushing
D. Door Stop
E. Center Hinge Spacer
F. Center Hinge
G. Screw Hole Covers
H. Top Cover
I. Upper Hinge
Note: When reinstalling
the refrigerator and freezer
doors, ensure that the
rubber gaskets are making
a good seal with the
cabinet before tightening
the screws.
1
2
3
4
5
6
7
8
9
5
A
B
C
D
B
D
B
E
F
B
C
G
H
I
E
F
B
C
A
B