Water Drainage - Danby DPA060BAUWDB Manual Del Propietário

OPERATING INSTRUCTIONS

WATER DRAINAGE

When the internal drain pan becomes full the
appliance will beep 8 times and the digital display
will show error code P1. The air conditioning or
dehumidifying action will stop but the fan may
continue to operate.
There are two methods to drain water from the
appliance.
1. Drain Plug
1. Turn the appliance off and unplug it from the
power source.
2. Carefully move the appliance to a location
where the water can be drained.
3. Remove the drain plug and allow the water to
completely drain.
4. Replace the bottom drain plug, pressing fi rmly to
ensure a tight fi t and no leaks.
5. The P1 error symbol will disappear and the
appliance will resume regular function once
power is restored.
2. Continuous Drain
During the dry mode, you may wish to set up the
continuous drain option so that the appliance will
automatically drain collected water.
Remove the exhaust hose during dry mode, it is
not necessary. Ensure that the appliance is turned
off and unplugged from the power source before
setting up the drain hose.
Remove the upper drain plug and attach the drain
hose that was provided with the appliance. Ensure
that there are no kinks or bends in the drain hose as
this can stop water from draining.
Place the open end of the drain hose over the
receptacle that the appliance will drain into; this
could be a basement fl oor drain, a sink or similar.
Remember that there is no drain pump in this
appliance, the continuous drain is activated by
gravity only. Ensure that the drain hose goes straight
down toward the fl oor from the drain connection.
If the hose is not positioned directly downwards,
water will not drain correctly.
1
2
11