Operating Modes - Danby DPA080BAUWDB Manual Del Propietário

OPERATING INSTRUCTIONS
CONTROL PANEL
1
Cool
2
Fan
3
4 Dry
1. Mode Button: Press to select the desired mode.
Modes will cycle in sequence with each press of
the button; Cool, Dry, Fan. A light will indicate
current mode.
2. Cool mode indicator light
3. Fan mode indicator light
4. Dry mode indicator light
5. LED Display:
• Shows the set temperature in °C or °F or the
auto-timer settings.
• While on Dry mode shows the relative humidity.
• When on Fan mode shows the room
temperature.
6. Power indicator light
7. Timer indicator light
8. Up and Down Buttons:
• Used to set the temperature and timer.
• Press and hold both Up and Down buttons for 3
seconds to change the temperature display from
°C to °F.
9. Power Button: Press to turn the appliance on or
off.
8 9
5
POWER
6 7

Operating Modes

• Cool Mode
Choose Cool Mode to set the cooling function. Use
the Up and Down Arrows to choose the desired
temperature. When Cool Mode is selected, the fan
speed can be adjusted by pressing the fan button.
The temperature can be set within a range of 17 -
30°C (62 - 86°F).
The exhaust hose should be installed during Cool
Mode to ensure the best results.
• Dry Mode
Choose Dry Mode to remove excess moisture
from the air during periods of high humidity. All
water pulled from the air will condense inside the
appliance and drain out the back.
The humidity can be adjusted in 5% increments
between 35% and 85%.
The fan speed will be automatically set and cannot
be modifi ed in Dry Mode.
• Fan Mode
Choose Fan Mode to run the internal fan without
engaging the cooling function. Press the fan button
repeatedly to choose the fan speed, Low, Med, High
or Auto.
• Auto Mode
Auto Mode is a pre-set factory program that
automatically defi nes the mode (Cool or Dry)
and fan speed based on the set temperature, the
ambient temperature and the ambient humidity.
Note that auto mode can only be activated from the
remote control.
7