ABC Design Salsa 3 Instrucciones De Uso página 9

Customer complaints
• No claims may be made for natural wear and tear or for damage caused by undue demands on the
product or by exceeding the permissible load.
• No claims may be made for damage caused by improper use.
• No claims may be made for damage caused by incorrect assembly or operation.
• No claims may be made for damage caused by improper modifications to the product.
• Areas of rust may appear through lack of maintenance or improper care and do not constitute a fault with
the product.
• Scratch marks are normal signs of wear and do not constitute a fault with the product.
• Mildew is likely to appear on textiles which are not dried out after getting wet and cannot be attributed to
shortcomings in production conditions.
• The product may fade if exposed to sunlight, perspiration and detergents, or if subject to abrasion or
excessive washing, therefore fading cannot be attributed to a fault with the product.
• No claims may be made for wheels which become worn out as a natural result of wear and tear.
1. Opening the carrycot
Extend and secure the side panels by pulling the two loops outwards until the bracket engages in the
mountings.
Make sure that the retainers are securely engaged.
2. Fitting the adapter to the carrycot
Fit the adapter onto the carrycot from below until it engages in the brackets provided.
Make sure that the adapter is securely engaged.
3. Inserting the mattress
Insert the mattress in the cover.
Lay the mattress on the base.
NB: The mattress is wedge-shaped. Make sure that the raised part is at the head end.
4. Adjusting the handle
To adjust the handle, press the buttons on both sides.
Now you can adjust the handle.
5. Fitting the hood
a. Fit the hood over the handle. Close the zip fastener on both sides.
b. Connect the Velcro fasteners on the bottom of the hood to the ones on the carrycot.
6. Fitting the apron
Fit the closed end of the apron over the lower end of the carrycot.
Extend the apron over the cot.
Secure the ends of the apron with the Velcro fastening provided on the outside of the hood.
EN - 06