Installation; General Preparation - Dru 55MF Instrucciones De Instalacion Y Uso

The appliance is supplied with the latch button
installed. As the latch button becomes hot during
use, a glove has been supplied, which you can use
to protect your hand.
The appliance is suitable for connection to outside
air supply. The appliance comes standard with a
connection kit necessary for this.
The appliance can be connected to the chimney at
the rear or at the top.
The appliance is suitable for the burning of wood,
brown coal briquettes and anthracite coal.
The appliance is supplied with a scraper for
removing excess ash.
The appliance is supplied with a separate handle,
the so-called "cold hand", to operate the riddling
rod.

Installation

General preparation

Please check the appliance immediately after
delivery for damage during transport or any other
damage or defects. The appliance is attached to
the pallet with screws at the bottom.
If you detect transport damage or any other
damage or defects, do not use the appliance
and notify the supplier.
Remove the detachable parts from the appliance
before you begin its installation.
It is easier to move the appliance and to avoid
damage if the removable parts have been
removed.
Note the location of the removable parts, so
that you can re-position the parts in the correct
place later on.
Subject to change because of technical improvements
1. Open the door; see the following figure:
2. Remove the fire-resistant inner plates; see the
following figure:
a. Remove the fire basket (3).
b. Take one of the inner plates (4) out of the
appliance.
c. Then remove the baffle plate (5)
d. Remove the second inner plate (4)
e. Remove the inner plates (1).
f. Remove grid holder (2), the grate (6) and the
ash pan (7).
Chamotte inner plates are ochrous on
delivery. They insulate the combustion
chamber, improving combustion and they
can withstand burning anthracite coals.
3
2
1
09-20021-050
09-20021-052
9