Dimensions; Eyewash Installation - Bradley S19-671H Instalación

Installation

Dimensions

35⁷⁄₈"
(911mm)
1 Eyewash installation — S19-671H
Remove the plastic dust plug from the bottom of the yoke
assembly and discard.
B
Connect the pressure gauge to the
adapter on the pressure side of the tank
with pipe sealant (by installer) .
NOTICE: When attaching the pressure
gauge to the tank inlet, hold the
adapter (item 3) with a wrench to
prevent stripping. Failure to do so
may damage the seal and cause
leakage. Max. torque 150 in-lbs.
Bradley • 215-321A Rev. AA; ECN 18-05-033
25¼"
(641mm)
10"
(254mm)
(152mm)
27¾"
(705mm)
Attach the eyewash yoke assembly to the
tank . Max . torque 150 In-Lbs . (The excess
heater cable from the yoke assembly will
be tucked into the heater jacket in a later
A
step .) Route the power cable through the
slot on the tank's side .
NOTICE: Check to ensure the heat trace
cable from the yoke assembly is not
kinked or damaged from assembly.
9/10/2018
S19-671H
6"
3