Dimensions; Eyewash Installation - Bradley S19-690HR Manual De Instalación

Installation

Dimensions

37⁵⁄₈"
(956mm)
1a Eyewash installation — S19-690HR
Disassemble Existing Eyewash
If the tank is pressurized, relieve the tank
A
pressure by pulling up on the relief valve
tab on the fill cover until pressure gauge
reads "0 . "
CAUTION: DO NOT open the cover or
remove the eyewash yoke assembly
until the pressure gauge reads "0."
Empty the tank of any
C
water and clean the tank .
Refer to "Clean Eyewash
Unit" on page 6 .
Bradley • 215-1749 Rev. C; ECN 18-05-033
24⁵⁄₈"
(625mm)
14"
(356mm)
27¾"
(705mm)
S19-690HR tank heater assembly for use with portable
pressurized eyewash models S19-690 and S19-690LHS
only. When used in conjunction with S19-690HR, it
becomes model S19-690H.
Disconnect and remove the old
B
eyewash yoke (and old heater belt
and jacket, if previously installed) .
Disconnect drench hose (if equipped)
and discard .
Inspect the tank fitting to ensure
it is clean and undamaged.
9/10/2018
S19-690HR
6"
(152mm)
3